Your kitchen and bathroom hold most of the fixtures in your home. They also see the most daily use. We handle both rooms, so you can fix a slow drain and replace a worn faucet in the same visit.
If your kitchen project also involves a gas range or cooktop, our gas and propane services team handles the gas line side of the work.
Some problems can wait a few days. Others should not.


Fixtures in Houston-area homes face conditions that fixtures in other cities do not. Knowing these three helps you understand why parts fail and what to watch for.
Hard water carries dissolved calcium and magnesium. The USGS classifies water above 121 mg/L of calcium carbonate as hard, and notes that scaling in equipment is one of the main reasons utilities try to avoid very hard water. You can look up local numbers in the annual drinking water quality report published by Houston Public Works.
Inside your home, mineral buildup shows up in predictable places:
Scale is also why a shower valve replacement sometimes makes more sense than another repair. If you want to slow the buildup at the source, ask about our water treatment services and how a water softener fits your home.
Much of the Houston area sits on clay-rich soil. Clay swells when it is wet and shrinks when it dries. Over years, that seasonal movement can shift a slab foundation slightly, and the drain lines cast into that slab move with it.
Watch for these patterns in a slab-built home:
These are not always foundation problems. Often it is a bellied drain line, a dry P-trap, or a blocked vent stack. A drain camera inspection tells us which one it is before anyone opens a wall or floor.
Pipe material tells us a lot about what to expect during a repair.
If several fixtures share the same weak pressure or rusty water, the issue may be the piping itself rather than the fixture. In that case, our whole-home repiping services team can inspect and advise.
We install showers and tubs as plumbing jobs, not cosmetic ones. That means correct drain placement, a properly sized water supply line, a code-compliant vent, and a pressure test before we close anything up.
A new shower is also a good moment to improve efficiency. EPA WaterSense labeled showerheads use no more than 2.0 gallons per minute compared with the 2.5 gpm standard, and the average family can save about 2,700 gallons of water per year by switching. WaterSense labeled bathroom sink faucets use a maximum of 1.5 gallons per minute at 60 psi, at least 30 percent below the federal standard of 2.2 gpm.
A tub-to-shower conversion is one of the most requested bathroom upgrades. Homeowners choose it for easier access, more usable space, or simply because the tub never gets used.
The plumbing work usually involves:
The shower pan is the waterproof layer under the shower floor. It catches any water that passes through tile and grout and sends it to the drain. A poor shower pan installation is the single most common reason a new shower leaks into the room next door.
We test the pan before the finish work starts. That one step prevents a hidden water leak that could take months to show up on a ceiling below.
Planning a shower or tub project? Call (832) 898-4922 to talk through the plumbing side before you buy materials.
We give you both options with the reasoning behind each. You choose.

Repair makes sense when the tank parts are worn, but the bowl and tank are sound. A toilet flapper replacement, fill valve swap, or wax ring replacement solves most running and seeping problems.
Replacement makes more sense when the porcelain is cracked, the flange is broken, or the toilet keeps clogging because of an old low-flow design. WaterSense-labeled toilets use 1.28 gallons per flush or less, compared with the federal standard of 1.6 gpf.

Repair works well when a single cartridge, washer, or aerator is the problem. Replacement is usually better when the body is corroded, the finish is failing, or parts are no longer made for that model.

A garbage disposal that hums but doesn’t work is often jammed, which is a repair. Leaks from the unit body, a burned-out motor, or repeated resets usually point to replacement of the garbage disposal unit.
We listen first. You describe what you are seeing and when it started.
We inspect the fixture and its supply, including the shut-off valve, water supply lines, and the drain below.
We diagnose. Depending on the problem, this may include leak detection equipment, a camera inspection, or a pressure check.
We explain your options in plain language, including repair and replacement paths.
We complete the approved work, then run the fixture and check for leaks.
We clean the work area before we leave.
For stubborn buildup, we use drain snaking or, when the line calls for it, hydro jetting. If the blockage sits past the fixture branch, we move to drain line services or sewer line services.
It depends on the scope of the work. The Houston Permitting Center states that a plumbing permit is required for plumbing fixtures and that a master plumber registered with the City of Houston must obtain it. Simple like-for-like fixture swaps are handled differently from work that adds, moves, or re-routes plumbing.



Because requirements depend on the project, we confirm the correct path for your address before work begins. You can also contact the Houston Permitting Center directly.

Licensed and regulated in Texas. Responsible Master Plumber License 46295, licensed and regulated by the Texas State Board of Plumbing Examiners. You can verify any Texas license yourself through the board's free public license search.

Residential only. We work on homes. That focus is why our technicians see the same kitchen and bathroom systems every day.

One company for connected problems. If a kitchen or bath issue involves your water heater, tankless water heater, sewer line, or gas line, the same team handles it.

Clear explanations before work starts. You hear what we found, what caused it, and what your choices are.

Local review history. Our Google profile shows a 5.0 average rating across 87 reviews as of this writing.

Experience. Planet Houston Plumbing lists 15+ years of experience serving Houston-area homeowners.
A slow shower drain is usually caused by a hair clog and soap residue buildup in the trap or branch drain. Mineral buildup can narrow the pipe further. If several drains slow down at once, the problem is more likely in the main drain or a blocked vent, which needs a camera inspection.
It depends on the work. The Houston Permitting Center requires a plumbing permit for plumbing fixtures, and a master plumber registered with the City of Houston must pull it. Moving drains or supply lines brings permitting and inspection into play. We confirm requirements for your address and scope before we begin.
Yes. We install customer-supplied toilets, faucets, sinks, and disposals. We first check that the model fits your rough-in measurements and drain position. One note: parts warranties on homeowner-supplied fixtures come from the manufacturer or retailer, not from us.
A straightforward faucet swap in an accessible cabinet is usually a short visit. Time increases when the angle stop is seized, the supply lines are corroded, the sink deck holes don’t match the new faucet, or mineral buildup has stuck the old fixture. We tell you what we find before we start extra work.
There is no single price. Cost depends on the tub type, whether the drain must be moved, the pipe material behind the wall, the condition of the existing supply lines, and whether the surrounding wall or floor needs work. We assess the space, explain the variables, and provide a plumbing estimate for your specific project.
Repair when the bowl and tank are sound and only internal parts are worn, such as the flapper, fill valve, or wax ring. Replace when the porcelain is cracked, the flange is damaged, the toilet clogs constantly, or repairs are stacking up. A newer model can also meaningfully cut water use.
The most common cause is a dry P-trap in a rarely used shower or sink, which lets sewer gas rise through the drain. Running water for a minute often solves it. If the smell continues, the cause may be a failed wax ring, a cracked drain line, or a blocked vent pipe, and you should have it inspected.
Hard water does not harm your health, but it leaves scale. The USGS notes that hardness comes from dissolved calcium and magnesium and that scaling in equipment is a well-known effect. In practice, scale clogs aerators and showerheads, stiffens shower cartridges, and leaves buildup on glass and tile. A water softener reduces it at the source.
Planet Houston Plumbing provides residential kitchen and bathroom plumbing throughout Houston, TX, and nearby communities. Our office is located at 24285 Katy Fwy, Katy, TX 77494. We serve homeowners in:
Whether you need Katy plumbing services, Cypress plumbers, Sugar Land plumbing help, a fix for one of many older Richmond, TX homes, or a residential plumber in Houston proper, we cover the area. Harris County homes and nearby Fort Bend communities are part of our regular service map, and Fulshear area homeowners are welcome to call, too.
Business hours: Monday to Friday, 8:00 AM to 6:00 PM. Saturday, 8:00 AM to 3:00 PM. Limited services available Sunday.
If you have a leak under the sink, a kitchen sink backing up into dishwasher lines, a leaking shower valve behind the wall, or a fixture you are ready to replace, we can help.
Tell us what you are seeing, and we will take it from there. Planet Houston Plumbing is a residential plumbing company in Houston, TX. If you have been searching for a licensed plumber near me, want to hire a master plumber for a bathroom remodel, or need kitchen remodel plumbing support, we are ready to help.